'TS' Tubing Swage 'TC' Tubing Gauge Paraffin Cutter

	'TS' Tubing Swage 'TC' Tubing Gauge Paraffin Cutter

'TS' Tubing Swage

ACT Tubing Swages are used to remove large obstructions and restore light collapse in the tubing. This allows smooth running of tool string in well bore. The OD of tubing swage should be equal to tubing drift ID. It should be run with up stroke jar to enable operator to take it out of tubing if swage is jammed.

Engineering Data for Tubing Swage
SIZE (IN.)	MAX. O.D. (IN.)	F/N. O.D. (IN.)	THREAD CONN. PIN X BOX (IN. TPI)	PART NO.
1-1/2	1.521	1.187	15/16-10 UN	101511
2	1.906	1.375	15/16-10 UN	102021
2-1/2	2.344	1.375	15/16-10 UN	102321
3	2.937	1.750	1-1/16-10 UN	103032
4	3.720	1.750	1-1/16-10 UN	103732

Other sizes available on request

'TC' Tubing Gauge Paraffin Cutter

ACT Gauge/Paraffin Cutters are run in hole before running sub surface equipment. Gauge/Paraffin Cutters are used to check if sub surface equipment can pass freely thru tubing & there are no obstructions and to locate top of nipple. The bottom of Gauge/Paraffin Cutter is suitable to cut paraffin, scale and any other obstacles in tubing.

Selection of size:
Example
Nipple bore = 2.25"
No Go ID = 2.197"
So, Gauge Cutter should be between above two sizes.

Engineering Data for Tubing Gauge Paraffin Cutter
O.D. RANGE (IN.) *	F/N. O.D. (IN.)	THREAD CONN. PIN (IN.-TPI)	PART NO.
0.905 - 1.575	0.875	5/8 - 11 UNC	831600
1.655 - 2.265	1.375	15/16 - 10 UN	832231
2.323 - 2.520	1.375	15/16 - 10 UN	832521
2.598 - 2.953	1.750	1.1/16 - 10 UN	832932
2.992 - 3.900	2.312	1.1/16 - 10 UN	833942
5.750 - 6.151	2.312	1.9/16 - 10 UN	836146

*Tubing Gauge/Paraffin Cutter are available in MM. increments within the Specified O.D. Ranges.
When ordering, specify required O.D. in MM (Inches x 25.4 = MM)

3084 South I-35W	Burleson, Texas 76028	Phone (817) 790-6608	Fax (817) 783-8081	www.americancompletiontools.com	sales@americancompletiontools.com
© American Completion Tools, Inc. - All Rights Reserved