Multi-Stage Setting Tool
Assembly Instructions

Home   Oils Tools Catalog   Service and Completion Oil Tools  Tool Shop  Contact American Completion Tools  Oils Tools Catalog 

Multi-stage Setting Tool Assembly Part 1
1. Install o-rings then lubricate o-rings and threads. Slide TOP PISTONS (10) in TOP CYLINDERS (9). Install RELEASE NUT and BOTTOM ADAPTER (15 & 16) to BOTTOM PISTON (13) then install this unit in BOTTOM CYLINDER (12).


Multi-stage Setting Tool Assembly Part 2
2. Screw CONNECTOR SUBS (11) into BOTTOM CYLINDER and one of TOP CYLINDERS. Make wrench tight. Wrench only on wrenching areas provided. Do not wrench on pistons anywhere except in knurled areas.


Multi-stage Setting Tool Assembly Part 3 3. Join TOP CYLINDER / TOP PISTON unit to CONNECTOR SUB / TOP PISTON unit. Make wrench tight.


Multi-stage Setting Tool Assembly Part 4 4. Join remaining TOP CYLINDER / TOP PISTON unit to CONNECTOR SUB / TOP PISTON unit. Make wrench tight.


Multi-stage Setting Tool Assembly Part 5


5. Remove tool from vise. Bump tool (view A) completely closed on wooden block. Next, turn tool Upright then fill TOP CYLINDER with motor oil until oil level reaches groove at lower end of thread. Install ORIFICE SUB (8). Excess oil will purge as sub is screwed in.


Multi-stage Setting Tool Assembly Part 6 6. Return tool to vise. Make ORIFICE SUB (8) wrench tight to TOP CYLINDER. Screw SHEAR SUB (7) to TOP PISTON. Hold back-up wrench on BOTTOM ADAPTER (16) and tighten SHEAR SUB which will ensure all inside connections are tight. Rotate SHEAR SUB clockwise until SHEAR SCREW holes align then install SHEAR SCREW (5).


Multi-stage Setting Tool Assembly Part 7 7. Install BLEEDER VALVE ASSY. (17) if used. Screw POWDER CHAMBER (6) to SHEAR SUB (7). Install POWER CHARGE. Make sure open end of power charge is facing up.


Multi-stage Setting Tool Assembly Part 8 8. Screw TOP SUB (2) to POWDER CHAMBER wrench tight. Check IGNITOR by first removing ground wire from contact spring then checking resistivity (51 ohms) with blasting galvanometer. Next, wrap ground wire around case of ignitor body then place ignitor in firing head. Tool is now assembled. Attach appropriate firing adapter, collar locator, and setting adapters.

Service & Completion Tool Products
3084 South Interstate 35 W, Burleson, Texas 76028
Office: (817) 790-6608 - Fax: (817) 783-8081
sales@americancompletiontools.com		 © American Completion Tools, Inc.
www.americancompletiontools.com
All Rights Reserved		 Flow Line Products
9223 Solon Rd., Houston, Texas 77064
Office: (281) 894-5213 - Fax: (281) 894-5217
sales2@americancompletiontools.com